Before starting the drum grinder, check whether the power supply is connected correctly, set the working time in the control panel, then pour the grinding material into the drum, and press the green start button to start the machine and start the operation.
The rotation speed of the drum can be adjusted steplessly through the speed control rotary button on the panel. When the preset working time arrives, the equipment will stop running on its own. This equipment uses the lift handle (for the model to drive the lift, press the lift button to complete), dump the barrel to take out the abrasive, and rinse it clean.
How the drum grinder works:
1. Before starting the machine, please check whether the connection of the power supply is correct, turn on the power supply, and observe whether the rotation direction of the motor is correct. The equipment has a discharge product for discharging the mixture of product and abrasive. After grinding, a container (such as a common plastic tray) can be rotated under the discharge product to hold the mixture
2. Water mill: Pour the product and abrasive into the drum, add abrasive, pay attention that the volume of the mixture should not exceed 60% of the capacity of the model, so as to facilitate rolling, and then press the upper cover tightly to prevent water leakage.
3. Dry polishing: Pour the product and dry polishing abrasive into the drum, add polishing paste, the overall capacity should not exceed 60% of the capacity of the model, so as to facilitate rolling, and then press the upper cover tightly.
4. When everything is ready, adjust the grinding time and frequency, turn on the power and start the grinding operation.
Notes on drum grinder equipment:
1. Pay attention to the waterproof and moisture-proof of the motor
2. Pay attention to the warranty of the power line. The power line must be covered with an insulating rubber tube to prevent leakage and short circuit from endangering personal safety.
3. The conditions for placing the drum grinder equipment need to be flat on the ground. If the vibration is large, the equipment can be fixed by the anchor screws.
