The operation of the vibrating grinder manufacturer:
1. Grinder drum loading and equipment: Loosen the fasteners on the lid, remove the lid, and place a certain amount of abrasive and operating agent, grinding additive and water in the container. The total load must not exceed 70 of the container. The water should be about 2-3cm above the object, then close the lid, tighten the nut, then put it into the hopper of the equipment container, press the pole and tighten the set screw.
2. Fixing of the disc: For convenience and loading and unloading of the reel, there are four jaws (that is, the brake lever positioning opening) on the wall plate of the disc tank. Every time you load or replace a brake drum, use the brake lever to clamp the desired azimuth bayonet to the brake disc.
3. Grinding operation of the grinder: Before grinding, pull out the brake lever and conduct a short-term operation check together. After the interruption, judge whether the drum is leaking, whether there is abnormal movement and static electricity, and whether the shoulder bar and stability are in place.
Grinding elements of the grinder:
1. Machine
A centrifugal grinder is a high-speed barrel polisher. It usually drives four (small and two) centrifugal polishing buckets to rotate at high speed through a large plate. Its impact is large and the polishing effect is good. It is often used for small parts that are difficult to be processed by swing polishing machines and drum polishing machines; eddy current machines are also a high-speed polishing machine. After the chassis rotates, a strong overcurrent conflict motion is formed, which is used for deburring, deburring and polishing of small parts.
2. Workpiece
For parts with the same data, parts with different standards, and parts with different requirements, vibratory mill manufacturers require different machines and grinding media to be assigned. For example, if the zinc alloy parts produced by die casting need to be descaled, resin grinding stones should be selected; stamping stainless steel parts should be continuously deburred, so brown corundum grinding stones with large cutting force should be selected
3. Grinding media
Abrasive media include abrasive and polishing materials such as grindstones, polishing stones, abrasives, and glosses. Each material has its own application plan. For example, plastic grindstones are used for soft materials, such as aluminum, zinc, copper, plastics, etc. Generally speaking, only by fully understanding the functions and characteristics of the three grinding elements of the grinder can the effective distribution be adjusted to achieve a multiplier effect.
